Rega Exon Especificações

ContentsImportant...1Introduction...

9Input ConnectionsAll connections are made using RCA (phono) type connectors. Thesockets on all Rega amplifiers are clearly marked red and white.Input

10LoudspeakersThe Rega amplifiers are capable of driving all normal hi-filoudspeakers. (Most loudspeakers have nominal impedance of 8Ω).If driving lo

11In UseSwitching OnDepressing the power switch to the left of the control panel turns onthe amplifier. The LED in the power button will flash.After s

12SpecificationsPower output @ 230V or 115V supply voltage.125 Watts into 8Ω..225 Watts into 4Ω..Input sensitivity for 125W and 225W into 8Ω and 4Ω.Po

13Check the mains supplyis connected and thesocket is switched onTroubleshooting(No power, power switch LED does not light up)Check the front panel po

14Troubleshooting(Power on, power switch LED lit but no output)Check the amplifier isconnected to the desiredinput and the correct inputis selectedChe

15Troubleshooting(Power on, sound from one speaker only)Are the connectionsbetween the speakerand the amplifier secureand functioningcorrectly?Check t

16Troubleshooting(Power on, power LED flashing but no output)Is the amplifier casebottom hot to touch?Let the amplifier cooldown, as on page 5section

17Owners Log(1)Owner...Date...

1ImportantThe Exon 3 is a unique amplifier where ingenious design has allowed anunusually high output from an exceptionally small size. Listen to its

2IntroductionYour Rega Mono-block has been designed to reproduce musiceffectively and easily. The Exon 3 has been built to Rega'sdiscriminating s

3Design InnovationIn common with all Rega products, the Exon 3 mono-block has beendesigned without compromise. Our time and money has been spenton dev

4General DescriptionThe Rega Exon 3 Power Amplifier is a 120 Watt 8Ω/200 Watt 4Ω highperformance, symmetrical circuit, Mono Block power amplifier, whi

5InstallationThe amplifier will work well on most surfaces, such as a shelf or atable, provided there is sufficient air around it to prevent overheati

6Amplifier and Speaker ProtectionThe power LED will flash if the following has occurred.1) Thermal cutout has been activated.If the amplifier reaches

7Short Circuit ProtectionIf in the event that the speaker leads are shorted, the short circuitprotection will protect the output stage from excessive

8Power Amplifier InputsThe Exon 3 can be used in conjunction with any pre-amplifier with astandard line output level (approximately 1V).The red (Input